Blar i SINTEF Open på forfatter "Røyset, Jostein"
-
The effect of Cu and Ge additions on strength and precipitation in a lean 6xxx aluminium alloy
Mørtsell, Eva Anne; Marioara, Calin Daniel; Andersen, Sigmund Jarle; Røyset, Jostein; Reiso, Oddvin; Holmestad, Randi (Peer reviewed; Journal article, 2015)It has been demonstrated that the strength loss in a lean Al-Mg-Si alloy due to solute reduction could be compensated by back-adding a lower at % of Ge and Cu. Nanosized precipitate needles which are the main cause of ... -
The effects and behaviour of Li and Cu alloying agents in lean Al-Mg-Si alloys
Mørtsell, Eva Anne; Marioara, Calin Daniel; Andersen, Sigmund Jarle; Ringdalen, Inga Gudem; Friis, Jesper; Wenner, Sigurd; Røyset, Jostein; Reiso, Oddvin; Holmestad, Randi (Peer reviewed; Journal article, 2016)We show how replacing a fraction of Mg with Li in a lean Al-Mg-Si alloy gives comparable strength and enhanced temperature stability. Replacing solute with smaller amounts of Cu and Li also improves thermal stability and ... -
Effects of Germanium, Copper, and Silver Substitutions on Hardness and Microstructure in Lean Al-Mg-Si Alloys
Mørtsell, Eva Anne; Marioara, Calin Daniel; Andersen, Sigmund Jarle; Røyset, Jostein; Reiso, Oddvin; Holmestad, Randi (Peer reviewed; Journal article, 2015)It is shown that strength loss in a 6060 Al-Mg-Si alloy caused by reduction in solute can be compensated by adding back smaller quantities of Ag, Ge, and Cu. Nine alloys were investigated. Ge was found to be the most ... -
The effects of quench rate and pre-deformation on precipitation hardening in Al–Mg–Si alloys with different Cu amounts
Saito, Takeshi; Marioara, Calin Daniel; Røyset, Jostein; Marthinsen, Knut; Holmestad, Randi (Peer reviewed; Journal article, 2014)The effects of quench rate after solution heat treatment in combination with 1% pre-deformation on precipitation hardening in three Al–Mg–Si alloys have been investigated by transmission electron microscopy and hardness ... -
The Effect of Elastic Strain and Small Plastic Deformation on Tensile Strength of a Lean Al–Mg–Si Alloy
Mørtsell, Eva Anne; Westermann, Ida; Marioara, Calin Daniel; Pedersen, Ketill Olav; Andersen, Sigmund Jarle; Røyset, Jostein; Holmedal, Bjørn; Holmestad, Randi (Journal article; Peer reviewed, 2019)Al–Mg–Si alloys are usually formed into their final shape by rolling or extrusion. After extrusion, the aluminium profiles are usually straightened, causing the material to be subjected to a small plastic deformation. This ...